Sears 645B Uživatelský manuál stáhnout pdf (Strana 4)

ASSEMI3LY INSTRUCTIONS

ATTACHING THE LOVUER A

■J LEAF RAMP SECTION

Hex Bolt

-5/16-18 X 8-3/8" Long

Flat ^

---------------------

Washer —\

5/16" I.D. if J 1

Hex Lock

Nut 5/16-18

Thread

IMPORTANT: This unit is shipped WITHOUT

GASOLINE or OIL. After assembly, see separate

engine manuai for proper fuel and engine oil rec

ommendations.

NOTE: To determine right and left hand sides of your

shredder, stand behind the unit with the engine the

farthest away from you. See figure 7.

Your shredder has been completely assembled at the

factory, except for the hopper, lower and upper leaf

ramp sections, chute deflector and the catcher bag.

The hardware pack and safety glasses are also

included in the carton.

The hardware pack contains the parts shown in figure

1 (shown full size).

TO REMOVE SHREDDER FROM CARTON

1. Remove staples, break glue on top flaps, or cut

tape at carton end and peel along top flap to

open carton.

2. Remove loose parts if included with unit (i.e.,

owner’s manual, etc.).

3. Cut along dotted lines and lay carton down flat.

4. Remove packing material.

5. Roll or slide unit out of carton. Check carton

thoroughly for loose parts.

TOOLS REQUIRED FOR ASSEMBLY

(1) Phillips Screwdriver

(2) 1/2" Wrenches (one must be a socket wrench)

(2) 7/16" Wrenches or Adjustable Wrenches

B ATTACHING THE UPPER LEAF RAMP SECTION

Truss Machine

Screws 1/4-20 x 1/2"

Long

Hex Lock Nu :s

1/4-20 Thread-

FIGURE 1.

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Sears 645B Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Nástroje Sears 645B