Sears 28.7123 Uživatelský manuál

Model No. 28.7123000-99-001012/0510Read and follow all Safety Rules and Operating Instructions before Every Use of this Product.SAVE THESE INSTRUCTIO

• 7 •GROUNDING AND AC POWER CORD CONNECTIONS8. RISK OF ELECTRIC SHOCK OR FIRE.This battery charger is for use on a nominal 120-volt 8.1 circuit and ha

• 8 •Attach the Foot:9.2 Remove the charger from the packing materials and place upside down on a at surface. Attach the foot and secure it with th

• 9 •Mount the Axle to the Charger9.4 : Place one end of each bracket into the slot on the bottom of the charger. Place the axle assembly under each

• 10 •FEATURES/CONTROL PANEL10. 213Output 1. Selector Switch #1Output 2. Selector Switch #2Ammeter3. Setting the Controls All controls for your charge

• 11 •OPERATING INSTRUCTIONS11. This battery charger must be properly assembled in accordance with the assembly instructions before it is used.Chargi

• 12 •After the engine starts, move Output Selector Switch #2 to the OFF position 7. and unplug the A.C. power cord before disconnecting the battery c

• 13 •MOVING AND STORAGE INSTRUCTIONS14. Store the charger unplugged, in an upright position. The cord will still conduct 14.1 electricity until it is

• 14 •PROBLEM POSSIBLE CAUSE REASON/SOLUTIONThe charger is making an audible clicking sound.Circuit breaker is cycling.Battery is defective.Shorted ba

• 15 •PROBLEM POSSIBLE CAUSE REASON/SOLUTIONCharger will not turn on when properly connected.AC outlet is dead.Poor electrical connection.Check for op

TABLE OF CONTENTSSECTION PAGEIMPORTANT SAFETY INSTRUCTIONS 2PERSONAL PRECAUTIONS 3PREPARING TO CHARGE 3CHARGER LOCATION 4DC CONNECTION PRECAUTION

• 1 •IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.SAVE THESE INSTRUCTIONS – The 71230 offers a wide range of features to accommodate yo

• 2 •IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS - 1. This manual contains important safety and operating instructionsRISK OF ELECTRIC SHO

• 3 •PERSONAL PRECAUTIONS2. RISK OF EXPLOSIVE GASES.NEVER smoke or allow a spark or ame in the vicinity of a battery or engine.2.1 Remove personal me

• 4 •Add distilled water to each cell until the battery acid reaches the level specied 3.4 by the battery manufacturer. Do not overll. For a battery

• 5 •FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE6. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK N

• 6 •FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE7. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK NEAR T